| Hangar |
Aircraft |
Category |
Date |
Preview |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Aug-20 11:06 |  |
| Views : 1752 |
| Mast attachment detail. Not sure if this is prototypical, but it follows how the rest of the boat is assembled. |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Aug-20 11:05 |  |
| Views : 1725 |
| I made this model for my friend who is turning his patio into a Tiki lounge. I thought is needed some more atmosphere to go with his woodworking and waterfall. |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Aug-20 11:02 |  |
| Views : 1889 |
| The completed canoe. |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Aug-20 11:00 |  |
| Views : 1778 |
| A small hole was drilled into the booms, and the end of a toothpick added to allow the rope an anchor to tie around. All the thread was run through a block of beeswax before use. |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Aug-20 10:58 |  |
| Views : 1829 |
| The outrigger added.All the wood received several layers of Minwax Polyurethane with lots of sanding in between coats. Final sanding was 600 and 1000 grit paper with a final buff coat of a paper towel, which gives the wood a nice soft sheen. Not too glossy. |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Aug-20 10:54 |  |
| Views : 1810 |
| After it was cut out I added looped stitching along the edges so it could get tied to the masts later. |
