| Hangar |
Aircraft |
Category |
Date |
Preview |
| John M Oshust | ManzanoLaser Royal Aircraft Factory B.E.12a | Build | 09-Feb-15 15:46 |  |
| Views : 766 |
| With the painting process still underway, we work toward the framing of the air foils, AKA, wings. |
| John M Oshust | ManzanoLaser Royal Aircraft Factory B.E.12a | Build | 09-Feb-15 15:45 |  |
| Views : 752 |
| We shall slow our pace, construct the center wing section over the cabane struts, fabricate a Lewis gun or two, mount them, add a bit of detailing to the fuselage, then address the wing issue. |
| John M Oshust | ManzanoLaser Royal Aircraft Factory B.E.12a | Build | 09-Feb-15 15:44 |  |
| Views : 798 |
| If we are lucky it will be spring and the wings can , “wait in the wings”, until next winter!! |
| rayl | Scratch Built Consolidated XF-92A | Build | 09-Feb-15 10:27 |  |
| Views : 1047 |
| Here is the first test fit; not bad. I will CA a ring of fine solder to the small end to ensure that it remains circular and give it a little strength. |
| rayl | Scratch Built Consolidated XF-92A | Build | 09-Feb-15 10:25 |  |
| Views : 992 |
| All shrunk down and ready to trim it out. |
| rayl | Scratch Built Consolidated XF-92A | Build | 09-Feb-15 10:24 |  |
| Views : 931 |
| I had a little time in the shop yesterday while the LOML was shopping, so I thought that I would do another "Shrinky-Dink' for the Afterburner tail piece. Here is the portion of the Coke bottle over the form before applying heat to it. |
