| Hangar |
Aircraft |
Category |
Date |
Preview |
| Skyediamonds1985 | Guillows Series 800 - Stearman PT-17 | Build | 06-Jul-15 20:01 |  |
| Views : 1057 |
| As you can easily surmise, this is kind of a two-step process. Prior to gluing the first strip, I cut the end at 45 degrees, using the scientific eyeball method. Then with the remaining edge from the strip already cut at the same angle, I carefully lined it up to verify the joint before cutting the short strip to size and then sjupergluing it into place. I carefully placed a dab of the glue along the underside of the strip prior to attaching it to the surface. I admit this method requires one to "get it right the first time or else" but figured it was worth the risk. I figured if I used white glue, it would act as a small bit of "lubricant" allowing the strip to slide around and thereby leaving a thin film of glue. |
| Skyediamonds1985 | Guillows Series 800 - Stearman PT-17 | Build | 06-Jul-15 19:53 |  |
| Views : 1079 |
| Next, I taped the strip ends onto scrap cardboard and spray painted metallic silver. I was careful not to flex the fold too much, lest it cracks the paint. |
| Skyediamonds1985 | Guillows Series 800 - Stearman PT-17 | Build | 06-Jul-15 19:49 |  |
| Views : 1064 |
| If you can look (zoom) carefully, I managed to open up the thin strip. Had to use a pair of tweezers to help. |
| Skyediamonds1985 | Guillows Series 800 - Stearman PT-17 | Build | 06-Jul-15 19:46 |  |
| Views : 1066 |
| This is where trial and error comes in and eyeballing is used. I carefully cut an extra thin strip along the folded edge of the paper, knowing that when I open it, the strip will be doubled in width. Don't want it too wide, or too thin. As Goldilocks would say, "Jes' about right." |
| Skyediamonds1985 | Guillows Series 800 - Stearman PT-17 | Build | 06-Jul-15 19:42 |  |
| Views : 1084 |
| For the metal borders surrounding the wing walk, this is where a bit of "outside the box" imagination comes in. I use a standard black white sheet of 81/2x11 sized paper folded in half. The fold of the paper will be used to form a "ridge" along the metal strip. |
| Skyediamonds1985 | Guillows Series 800 - Stearman PT-17 | Build | 06-Jul-15 19:38 |  |
| Views : 1100 |
| Carefully checking each strip for appropriate size and then supergluing them into place. |
