| Hangar |
Aircraft |
Category |
Date |
Preview |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Build | 19-Apr-16 20:28 |  |
| Views : 836 |
| Finished results. The small indentations, are from my previous attempts using rub-off letters without much success. With the self-adhesive letters, the small dents are barely noticeable. The engine cover was already glued in place. So that precluded any chance of redoing the whole cover. Stuff happens.... |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Build | 19-Apr-16 20:25 |  |
| Views : 845 |
| I carefully laid down the "holed" letters onto a sheet of paper. Using a rattle can of Temiaya Olive Drab, I sprayed the letters. After they were dried, I carefully lifted them off the sheet. Because they're self-adhesive, I simply stuck them into place. No glues, no mess. I could even relocate them into their final place, if necessary |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Build | 19-Apr-16 20:19 |  |
| Views : 786 |
| Used a "T" pin to poke a hole |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Build | 19-Apr-16 20:18 |  |
| Views : 798 |
| Obtained some self-stick vinyl letters from a local arts and crafts store. Pulled out the "O" from the centers of the letters "b." Seemed to be about the right size. |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Build | 19-Apr-16 20:13 |  |
| Views : 753 |
| Going to replicate the small hatches holding down the engine cover |
| Anders | Guillows Series 400 - BF 109 | Build | 18-Apr-16 15:52 |  |
| Views : 1104 |
|
