| Hangar |
Aircraft |
Category |
Date |
Preview |
| LASTWOODSMAN | Dumas Kit #233. MiG 17 | Parked | 27-Dec-16 16:46 |  | | Views : 5416 | | CANOPY COCKPIT FRAME The clear 0.020" thick cockpit canopy frames were made as follows... I used white printer paper to cut thin strips for the frames by sizing and recutting and test fitting them over the canopy frame. When they all fit and matched the frame nicely, I traced them onto the back of a Top Flite Trim Sheet (peel 'n stick) - but did not cut them out yet. On the coloured front of the trimsheet, I used the same acrylic paint colors that I mixed up that matched the camo tissue colors, and painted over the whole front of the color side of the trim sheet in the same camo pattern and let it dry. |
| LASTWOODSMAN | Dumas Kit #233. MiG 17 | Parked | 27-Dec-16 16:37 |  | | Views : 5527 | |
| LASTWOODSMAN | Dumas Kit #233. MiG 17 | Parked | 27-Dec-16 15:34 |  | | Views : 8586 | | I used acrylic paints mixed up as best I could to match the camo tissue covering. |
| LASTWOODSMAN | Dumas Kit #233. MiG 17 | Parked | 27-Dec-16 15:32 |  | | Views : 5272 | | PAINTING: The infil-planked forward fuse, the built-up nose cowl, the stiff paper rear fuse fairing, the vac-formed plastic jet engine nozzle fairing, the wing fences (which were really hard to make and glue on), the main gear nose wheels and doors, were all brush painted. |
| LASTWOODSMAN | Dumas Kit #233. MiG 17 | Parked | 27-Dec-16 15:24 |  | | Views : 5392 | | Later versions were also equipped with four - Kaliningrad K-5, air to air missiles. These were "beam-riding guidance", short-range, anti-bomber missiles. |
| LASTWOODSMAN | Dumas Kit #233. MiG 17 | Parked | 27-Dec-16 15:20 |  | | Views : 7793 | | The 3 cannons were mounted under the nose in a removeable gun pack. |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| LASTWOODSMAN | Dumas Kit #233. MiG 17 | Parked | 27-Dec-16 15:17 |  | | Views : 1021 | | The Mig 17 had 3 cannons - two: 23 mm Cannon, 80 rounds per gun, 160 rounds total. And one 37 mm cannon, 40 rounds total. |
| LASTWOODSMAN | Dumas Kit #233. MiG 17 | Parked | 27-Dec-16 13:11 |  | | Views : 1077 | | The Mig 17 was one of the most widely produced jet A/C ever made - in excess of over 12,000 were produced. It never saw action in the Korean War. The jet engine was a Klimov VK afterburning turbojet with a thrust of 5,955 lbf, and 7,423 lbf with afterburner. The afterburning turbojet increased thrust by dumping fuel into the exhaust of the basic engine. Top speed was 711 mph. |
| LASTWOODSMAN | Dumas Kit #233. MiG 17 | Parked | 27-Dec-16 13:03 |  | | Views : 954 | | The purpose of the wing fence was to obstruct the span-wise airflow along the wing, to prevent the entire wing from stalling at once. The Mig 17 wing also lacked taper that the Mig 15 had. |
| LASTWOODSMAN | Dumas Kit #233. MiG 17 | Parked | 27-Dec-16 13:00 |  | | Views : 906 | | The wing fence was often seen on swept-wing A/C, and was located on the upper wing surface and wrapped around to the leading edge. |
| LASTWOODSMAN | Dumas Kit #233. MiG 17 | Parked | 27-Dec-16 12:55 |  | | Views : 784 | | The Mig 17 (advanced from the Mig 15 of the Korean War - where the Mig 15 fought the F86 Sabre), had the easily visible difference of an added "ventral fin" under the rear fuselage (the Mig 15 had none), and the Mig 17 also had an added third "wing fence" on each wing. |
| LASTWOODSMAN | Dumas Kit #233. MiG 17 | Parked | 27-Dec-16 12:47 |  | | Views : 803 | |
|
