Browse Images

Virtual Aerodrome Image Browser ( Small / Large )

Hangar	Aircraft	Category	Date	Preview
LASTWOODSMAN	Herr Engineering HRR 105, Fokker D-7	Parked	23-Apr-17 18:29
Views : 742
mlriley - you inspired me to put in new rubber, a downthrust angled balsa plate on the front, and a metal "rubber hook" for the prop hook to rubber connection, into my 22" Sig Cabinaire. It was still balanced.
mlriley540	Scratch Built Morane-Saulnier MS 406	Flying	23-Apr-17 15:59
Views : 4597
Short 3 minute flying session, the nose assembly for the prop broke. It was made out of wood. Otherwise plane is fine. I can craft a new one in an hour or so.
BriandKilby	Guillows Series 500 - P-40 Warhawk	Build	23-Apr-17 15:58
Views : 3635
sherman m4a3e8 "easy eight" tank. it's been a while since i built a tank. so i'll give a shot.
heywooood	Dumas Kit #401, Laird Super Solution	Parked	23-Apr-17 15:52
Views : 947
you can see the detail in these parts..
heywooood	Dumas Kit #401, Laird Super Solution	Parked	23-Apr-17 15:51
Views : 1018
crankcase has been assembled and painted
heywooood	Dumas Kit #401, Laird Super Solution	Parked	23-Apr-17 15:44
Views : 990
thank you James for adding the Laird Super Solution to our hangar selections list.

Hangar	Aircraft	Category	Date	Preview
LASTWOODSMAN	Herr Engineering HRR 105, Fokker D-7	Parked	22-Apr-17 22:12
Views : 772
The other side of the planks is painted Bronze Metallic. There are three coats of acrylic brush on paint on each side of eight planks = 48 sides were painted.
LASTWOODSMAN	Herr Engineering HRR 105, Fokker D-7	Parked	22-Apr-17 22:08
Views : 763
Planks are blocked up securely and painted on one side with Burnt Sienna Brown Gloss.
LASTWOODSMAN	Herr Engineering HRR 105, Fokker D-7	Parked	22-Apr-17 21:57
Views : 805
I cut out eight balsa prop lamination planks - 10" X 1 1/2" X 1/16" - to paint up for wood grain, and then glue them stacked on top of each other to make a balsa prop block to carve the Axial prop for the 200 HP BMW engine.
LASTWOODSMAN	Herr Engineering HRR 105, Fokker D-7	Parked	22-Apr-17 21:45
Views : 834
This is the other Axial prop made for the 160 HP Mercedes engine for a Fokker D7.
LASTWOODSMAN	Herr Engineering HRR 105, Fokker D-7	Parked	22-Apr-17 21:42
Views : 845
I just figured out the "Snipping Tool" to get a good image of the Axial prop for the 200 HP BMW engine for the Fokker D7 - this is the one I drafted.
mlriley540	Scratch Built Morane-Saulnier MS 406	Build	22-Apr-17 13:06
Views : 2648
I applied some tissue at the wing root, built up the tail wheel, and added a sandable mix to the lower nose which was also damaged in crash. Should be fine.

All pictures are property of the individual members of this site.
They may not be used without permission from the user.