| Hangar |
Aircraft |
Category |
Date |
Preview |
| pfinn | Scratch Built Holiday | Build | 17-Oct-19 16:17 |  | | Views : 756 | | Added a carbon fiber square tube to help transfer some of the torsional load and support the soon to be installed control pin (or tube, haven't decided yet) and as well as beef up the structure a bit for the "not so graceful" end of flights! ;) |
| pfinn | Scratch Built Holiday | Build | 17-Oct-19 16:11 |  | | Views : 781 | | The "Pivot" tube is 5mm I.D. brass. The joiner is Carbon Fiber. Hard balsa saddles the brass tube and the ends are wrapped with Kevlar tow. Another pin will be added about 2.5 inches behind the pivot for control. |
| edbecky | Guillows Series 1000 - F4U Corsair | Build | 17-Oct-19 12:28 |  | | Views : 4728 | | I made a simple variation of John's bearing solution. Slipped painted part of a straw over the dowel. Used bending part of the straw to keep it from sliding out. Inserted and glued straw to the model. Works well. |
| pfinn | Scratch Built Holiday | Build | 16-Oct-19 03:27 |  | | Views : 874 | |
| pfinn | Scratch Built Holiday | Build | 16-Oct-19 03:26 |  | | Views : 799 | |
| pfinn | Scratch Built Holiday | Build | 16-Oct-19 03:25 |  | | Views : 808 | | The TE is three 1mm (.040") square basswood I found at a German Crafts store with some .012" thick Carbon strip I already had. |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| pfinn | Scratch Built Holiday | Build | 16-Oct-19 03:21 |  | | Views : 836 | | Decided to add leading edge sub-ribs instead of sheeting the LE with 1/64" ply. I also decided to add Diagonal cross bracing rearward of the main spar. And again, radiused gusseting. Sometimes I wonder...this is supposed to be a "Quick" build. Sheesh. |
| pfinn | Scratch Built Holiday | Build | 16-Oct-19 03:11 |  | | Views : 785 | |
| pfinn | Scratch Built Holiday | Build | 16-Oct-19 03:10 |  | | Views : 869 | | Since the airfoil is not flat bottom, small tabs lift the ribs of the building surface to keep the oriented correctly. These tabs will be removed later. Notched LE and TE really help with this kind of technique. The top spar is not bonded at this time in lieu of adding the vertical grain shear webs. |
| pfinn | Scratch Built Holiday | Build | 16-Oct-19 03:03 |  | | Views : 811 | | LE laminated from four 1/32" Balsa strips. Marking for Rib notches. |
| pfinn | Scratch Built Holiday | Build | 16-Oct-19 02:54 |  | | Views : 786 | | Only the outer side was laminated with the Carbon to facilitate a better bond with the "Shear webs" further down the line. |
| pfinn | Scratch Built Holiday | Build | 16-Oct-19 02:51 |  | | Views : 672 | | Carbon fiber "Tow" is laminated to the outer side of the Basswood cores. Tauten the the dry fibers on a flat nonstick surface (packing tape on the building board this time) then squeegee(?) Epoxy to "Wet Out" the fibers. Carefully pull the fibers off the surface and transfer to Basswood cores. Clamp between flat surfaces for curing. |
|
