| Hangar |
Aircraft |
Category |
Date |
Preview |
| SteveM | Peck Polymers One Nite 28 | Build | 08-Mar-08 23:15 |  |
| Views : 1331 |
| KP-01 motor is retained with three 2-56 nylon screws. The holes were drilled and taped, a little thin CA wicked into the wood, then taped again. |
| SteveM | Peck Polymers One Nite 28 | Build | 08-Mar-08 23:13 |  |
| Views : 1316 |
| 3x110 mAh NiCd and 5 amp fuse (goes into the yellow socket) acts as a switch. Fuselage also had 4" cut off of the front. |
| SteveM | Peck Polymers One Nite 28 | Flying | 08-Mar-08 18:36 |  |
| Views : 1283 |
| These flights are all done with hand winding as the winder broke and CA wouldn't hold it together. I managed to get some 15-20 second flights and then decided my poor wrist and finger were tired of winding and it was time for electric FF conversion. |
| SteveM | Peck Polymers One Nite 28 | Flying | 08-Mar-08 18:33 |  |
| Views : 1240 |
| Went to the park today and tried the One Nite 28 with rubber powered FF. |
| wingspanner | West Wings Spitfire Mk 22/24 | Build | 08-Mar-08 18:04 |  |
| Views : 2152 |
| Managed to get the Engine rocker fairings glued and gave the whole plane a few coats of Krylon. Busy setting the tailplane and fin in place. Then to coat it with primer and an attempt at airbrushing. |
| John M Oshust | Scratch Built Polikarpov I-16 Rata | Build | 08-Mar-08 17:50 |  |
| Views : 1122 |
| I must be feeling normal, 6 hrs today and the wing root is totally covered. |
