| Hangar |
Aircraft |
Category |
Date |
Preview |
| David Duckett | West Wings F-117a Nighthawk | Build | 05-Jun-08 23:31 |  | | Views : 5762 | | Not quite finished yet... |
| SteveM | Molt Models Tyro | Flying | 05-Jun-08 23:31 |  | | Views : 1449 | | These are almost all of the pylon racing planes, the boys from Knife Edge Software showed up just after this photo op. |
| Jedi | Guillows Series 400 - P-40 Warhawk | Build | 05-Jun-08 22:12 |  | | Views : 7487 | | Lines and the inside |
| SteveM | Molt Models Tyro | Flying | 05-Jun-08 15:12 |  | | Views : 1390 | | Near ground there was a gentle breeze down the runway, but about 30' up there was a strong wind pretty much cross runway. Moving between these two layers of air was very exciting and kept me on my toes. I failed today as the Tyro came home in one piece. |
| SteveM | Midwest Products Aero-Star .40 | Build | 05-Jun-08 00:35 |  | | Views : 1016 | | View of the right wing before the sheeting goes on. The spars are 1/4" sq. spruce but everything else is balsa. It's almost embarrassing to admit this, but other than trimming a few of the webs and one sheet to fit, I haven't had to sand or cut anything. |
| John M Oshust | Top Flite F4U Corsair | Build | 04-Jun-08 18:21 |  | | Views : 1071 | | Clamped to a card table, you are seenig about 43 inches of fuse! |
|
|
