| Hangar |
Aircraft |
Category |
Date |
Preview |
| edtherenderman | Scratch Built Bugatti 100P | Build | 14-Nov-21 19:44 |  |
| Views : 793 |
| Taking a break for the holidays so thought I’d post the current state of the Bugatti. 3D printed exhaust fairing and cooling air outlets that are on the trailing edge of the wings. Glued and filled with spackling, then coated entire model with five coats of thinned EZ-DOPE. Finally, two coats of sanding primer. Next will be sanding the primer and filling anything that needs it. |
| mark eggebeen | Guillows Series 2000 - B17 Flying Fortress | Parked | 12-Nov-21 22:55 |  |
| Views : 1253 |
| Major surgery !! I forgot to install the guides for the nacelle rails on one wing . Now I built the nacelle and am using it to align the guides with the rails |
| BriandKilby | Guillows 1903 Wright Flyer | Build | 12-Nov-21 13:24 |  |
| Views : 872 |
| wondering if staining the propellers would look better than painting or leaving it normal? what do you guys think? |
| mark eggebeen | Guillows Series 2000 - B17 Flying Fortress | Parked | 11-Nov-21 22:24 |  |
| Views : 1002 |
|
| Don C | Scratch Built Vultee BT-13 | Build | 10-Nov-21 21:24 |  |
| Views : 789 |
| This should be 1st . ready to go. Oven heated to 280. Let it heat for about 5 minutes, then move quickly. If it doesn't go all the way down over the mold, back in the oven for a longer time. It will flatten out and give you a second chance.. |
| Don C | Scratch Built Vultee BT-13 | Build | 10-Nov-21 21:18 |  |
| Views : 809 |
| Its helpful to mark where to cut before removing it from the form. I made 2 in case I messone up fitting or painting. |
