Browse Images

Virtual Aerodrome Image Browser ( Small / Large )

Hangar	Aircraft	Category	Date	Preview
David Duckett	Cleveland Lockheed P-80	Build	20-Sep-13 06:33
Views : 999

julinick	Easy Built D-03 Avro Lancaster	Build	19-Sep-13 19:29
Views : 1195
My son built me the mold boxes for me. The spinner didn't look right, so I'll have to re-do it.
julinick	Easy Built D-03 Avro Lancaster	Build	19-Sep-13 19:23
Views : 1106
Held on by tape, a little sanding, then will be glued.
julinick	Easy Built D-03 Avro Lancaster	Build	19-Sep-13 19:22
Views : 1058
The first good engine cowling. This is a rubber mold from Alumilite and so is the casting resin. The resin is called Amazing Casting Resin purchased from Michael's and cures hard in 10 minutes.
julinick	Easy Built D-03 Avro Lancaster	Build	19-Sep-13 19:20
Views : 1009
First one was a test run, turned out great. The one in the mold is the good one.
deckape	Scratch Built Holiday	Parked	19-Sep-13 00:04
Views : 5764

Hangar	Aircraft	Category	Date	Preview
deckape	Scratch Built Holiday	Parked	19-Sep-13 00:03
Views : 5754

deckape	Scratch Built Holiday	Parked	19-Sep-13 00:03
Views : 5735

deckape	Scratch Built Holiday	Parked	19-Sep-13 00:03
Views : 5815
Here is my Tumpeter 1/48 scale HU-16B Albatross the finish was used is Areo gloss silver aluminum dope thinned down with laquer thinner,
David Duckett	Cleveland Lockheed P-80	Build	18-Sep-13 17:08
Views : 1012

David Duckett	Cleveland Lockheed P-80	Build	18-Sep-13 17:07
Views : 978
A lot of infill is ahead before the wings can be attached to the fuselage and that has to be done before the intakes can be made. It now weighs 2.1 oz/59 grams.
David Duckett	Cleveland Lockheed P-80	Build	18-Sep-13 17:03
Views : 1054
The wings are made with three pieces of 1/8" x 1/4"for upper and lower spars and trailing edge plus 1/8" square stock for the leading edge.

All pictures are property of the individual members of this site.
They may not be used without permission from the user.