| Hangar |
Aircraft |
Category |
Date |
Preview |
| David Duckett | Guillows Series 200 - DH4 | Reference | 03-Apr-15 18:34 |  |
| Views : 4305 |
| From the rear |
| David Duckett | Guillows Series 200 - DH4 | Reference | 03-Apr-15 18:34 |  |
| Views : 4415 |
| Maybe this will help. I made this from the Guillows plans but I see the shape of the one you're working on is basically reversed; the leading edge here is straight, more or less. |
| John M Oshust | ManzanoLaser Royal Aircraft Factory B.E.12a | Build | 03-Apr-15 17:25 |  |
| Views : 1159 |
| Ogre airscrew take two. The blanks that I first cut were not wide enough to shape the airscrew properly. I had hoped to make two, almost identical, two bladed airscrews, and them joint them into a four bladed unit. Shaping the complex curves on two individual propellers greatly “confuzeled “ my brain. The neurons fired but the synaptic connections repeatedly reversed the thought pattern. Right becoming left, top becoming bottom. This short circuit was magnified by the clockwise airscrew rotation. Up until Ogre all of my Props have been anticlockwise in rotation. I wonder what would happen if I drove my lorry in England? Disaster, I am sure! |
| John M Oshust | ManzanoLaser Royal Aircraft Factory B.E.12a | Build | 03-Apr-15 17:23 |  |
| Views : 1144 |
| The glued and assembled four bladed airscrew awaits tomorrow’s shaping. In this form my thought process should be a bit more direct and clear. What is done to one blade is repeated on the others. Coloring the upper surface with a marker, prior to shaping, should produce a sanding pattern pointing to symmetry. Repeated coloring and shaping hopefully yield the desired result. “Lettuce” see if this works. To be near scale, the airscrew blades need to be 12 inches in length. |
| JohnG. | Monogram Speedee Cessna Seaplane | Build | 03-Apr-15 11:02 |  |
| Views : 1974 |
| With the B-25 temporialy shelbed...THIS is the next project. |
| David Duckett | Dave Diels Engineering, Inc Kit #29 Hawker Typhoon Mk 1B | Build | 03-Apr-15 02:52 |  |
| Views : 897 |
| I let the sheet dry for a couple of says and then did a test on foam board I've been using to paint on canvas with. Success!! The decals are now quite strong and can be handled with ease.That's comforting as I have three more Diels kits in the closet:-) |
