| Hangar |
Aircraft |
Category |
Date |
Preview |
| David Duckett | Dumas Kit #313, Hawker Hurricane | Build | 18-Oct-09 21:38 |  | | Views : 1024 | | The silkspan didn't adhere to the inner stringers so....I used the tip of my xacto blade and made several small holes along the stringer and then put on a small amount of CA and used my finger to press it into place, an operation best done quickly |
| David Duckett | Dumas Kit #313, Hawker Hurricane | Build | 18-Oct-09 21:35 |  | | Views : 951 | |
| David Duckett | Dumas Kit #313, Hawker Hurricane | Build | 18-Oct-09 21:34 |  | | Views : 980 | | A second coat of filler was applied to the wing and fuselage and sanded smooth. Then two coats of nitrate dope was applied and sanded smooth. The bottom was then wet covered and given two coats of dope and the bottom fin pieces were glued in place on either side of the wire. This first side section is 3 1/2" wide. |
| David Duckett | Dumas Kit #313, Hawker Hurricane | Build | 18-Oct-09 13:27 |  | | Views : 930 | | The bottom is ready for covering. Two balsa pieces fit on either side of the tailwheel wire and will be added when covering is finished. |
| David Duckett | Dumas Kit #313, Hawker Hurricane | Build | 17-Oct-09 00:11 |  | | Views : 923 | |
| David Duckett | Dumas Kit #313, Hawker Hurricane | Build | 17-Oct-09 00:09 |  | | Views : 967 | | Tailwheel unit glued in place but there are two more pieces to it. This is not the "plan way". The kit supplied tailwheel is a Guillows 1" standard item and too large so it will not be used. The roundel is from a Guillows Spitfire kit. |
|
|
