Browse Images

Virtual Aerodrome Image Browser ( Small / Large )

Hangar	Aircraft	Category	Date	Preview
David Duckett	House of Balsa FW-190	Build	10-Nov-07 09:43
Views : 1084

David Duckett	House of Balsa FW-190	Build	10-Nov-07 09:41
Views : 1008
As soon as it's daylight, and warm enough, I'll start covering these outside. There's too much area involved to use dope inside. The frames have all been prepped with two coats of 50/50 white glue/water (more or less) and sanded smooth.
David Duckett	House of Balsa FW-190	Build	09-Nov-07 07:21
Views : 1044
Sanding
David Duckett	House of Balsa FW-190	Build	06-Nov-07 22:04
Views : 1009
Tail feathers are now 5/16" thick. Cowl bumps are made from 1/4" blocks.
David Duckett	House of Balsa FW-190	Build	06-Nov-07 22:02
Views : 908
The tail feathers-3/32" pieces glued to a sheet of 3/32" and then to another.
David Duckett	House of Balsa FW-190	Build	06-Nov-07 22:00
Views : 971
Except for the1/8" spar top and bottom this is all 1/16". There's another 1/8" piece under the trailing edge.

Hangar	Aircraft	Category	Date	Preview
David Duckett	House of Balsa FW-190	Build	04-Nov-07 17:00
Views : 985
Blue tape removed and filler sanded smooth. The blue tape will now go back on until The covering process starts.
David Duckett	House of Balsa FW-190	Build	04-Nov-07 16:56
Views : 887
Scale check for Moostang
David Duckett	House of Balsa FW-190	Build	04-Nov-07 16:54
Views : 984
The canopy portion has been masked to protect it during the micro-fill phase.
David Duckett	House of Balsa FW-190	Build	04-Nov-07 16:51
Views : 1068

David Duckett	House of Balsa FW-190	Build	04-Nov-07 16:49
Views : 935
The plastic piece was glued to the cockpit assembly and the excess plastic was trimmed from the bottom. The 1/4" supports were removed from the bottom and it's now being glued in place.
David Duckett	House of Balsa FW-190	Build	03-Nov-07 19:31
Views : 972

All pictures are property of the individual members of this site.
They may not be used without permission from the user.